ASTM D1120

ASTM D1120 – Standard Test Method for Boiling Point of Engine Coolants

Description:

Abstract

This test method establishes the standard procedures for the determination of the equilibrium boiling point of engine coolants. The equilibrium boiling point indicates the temperature at which the sample will start to boil in a cooling system under equilibrium conditions at atmospheric pressure. This method requires the use of the following apparatuses: round-bottom, short-neck, heat-resistant glass flask; water-cooled, reflux, glass-tube type condenser; grit No. 8 boiling stones of silicon carbide grains; partial immersion thermometer; and electric heating mantle as heat source. Specified amounts of the sample shall be boiled under equilibrium conditions at atmospheric pressure in the flask. The temperature of the liquid corrected for barometric pressure shall be the boiling point.

Scope

1.1 This test method covers the determination of the equilibrium boiling point of engine coolants. The equilibrium boiling point indicates the temperature at which the sample will start to boil in a cooling system under equilibrium conditions at atmospheric pressure.

NOTE 1: Engine coolants may also be marketed in a ready-to-use form (prediluted). This test procedure is applicable to diluted solutions as well as to concentrates.

NOTE 2: The procedure for obtaining a representative test sample of a coolant solution that contains an antileak additive is found in Practice D1176.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.